?зменения в софте 5v27z в сравнении с 5v27l
These are the User differences from 5v27L software to 5v27Z software;
// Calibration
Water limp home upper limit lifted from 200.0 to 230.0 DegC
New GPC names added
Ignition timing clamps limits are now at max/min allowed values so that fixed ignition timing can be generated that is table independent.
User defined analogue channels allow limp home values to Min/Max possible value
50% dwell now uses the 2/4 stroke and the number of even ignition events to calculate the 50% dwell time
// Help updates
TPS low error
CLC
Cam pulse select min
Cylinder events/cam event
Launch rpm trigger
GPC inhibit
PC Data streams
// Injectors added
Bosch 0280155968
Bosch 0280155931
Bosch 0280156123
Accel 150136
MORAN #225
JECS ID10
VDO FI114991
Siemens-DEKA 9068A01085
RC Racing PL8-500 corrected to PL8-550
Generic injector times specified as "@12.0Volts"
// Test functions
M0 test fixed ignition timing menu added. Ignition fixed at 10 degrees
// Triggers
Honda S2000 (1) corrected and Help mentions name "F20C"
Honda S2000 (2) Sync=Reluctor and lead angles are 410..430
Nissan QR25 trigger modified & tested
Trigger decoder import bug fixed
// Ignition sequence
Edit Ignition index (Base angles) list shows then index number & angles
// Live data
EngSpd&Hysteresis added
// Wiring diagram
Added CDI wiring diagrams (Standard & Rotary 4coil)
// File Dialogue
Left key =Jumps to back folder option.
Right key=Jumps to next folder
Option to force the logger path to the calibration file path
// Comms
CommError dialog upgraded message regarding alternative dual cal map swapping
// AutoComPort
Searches for a communication port & goes on line if detected an ECU on that port
// PC data stream
Added "SM4 1.09 & above" & added data stream that allows the Dyno Setpoint to be controlled by the PC calibration software
// Compare
Modified to show multiple items under same heading
===
Теперь по нашему
Добавления отличная функция сравнения изменения калибровочного фала, если раньше приходилось просто ходить по всем окнам и усматривать изменения, то теперь, кликая на -
show compare differences получаешь сразу полный детальный список изменений и сразу попадаешь в это место для изучения...
// Калибровки
Расширен темп режим для лимп хом ож, был 150-200, сделали 150-230гр С
Увеличено серьезно кол-во и варианты названий GPC каналов
Ignition timing clamps limits are now at max/min allowed values so that fixed ignition timing can be generated that is table independent. = это пока не понял
что то с точностью пределов по зажиганию
Увеличен диапазон лимп хом в сетапе для аналоговых каналов
50% dwell now uses the 2/4 stroke and the number of even ignition events to calculate the 50% dwell time = это с двелл
// ?зменения в хелпе
TPS low error
CLC
Cam pulse select min
Cylinder events/cam event
Launch rpm trigger
GPC inhibit
PC Data streams